Invalidating stale software suspend images done sex dating in novinger missouri

5) Possibly create a cron entry to re-start the utility and therefore the ntp daemon periodically I have started writing a script for step 4 and will post it when i have completed it and done some testing, hopefully we can resolve this fully before the next image is compiled.

If you are not totally confident with doing these changes please hang on until a couple of other users have tried it and hopefully confirmed it's ok, I see no reason for it not to work but I really would not like to be responsible for any corrupted or loss of data. Paul I was of the same opinion that "Something doesn't sound quite right there" despite my doubt, my understanding was the ntpd -g was not repeated after a successful internet connection was established, although I could not find anything official to absolutely verify this one way or the other I did trawl through many forum discussions, guides and tutorials to arrive at that conclusion, it makes far more sense to only adjust the time after successfully confirming the correct time with live ntp servers over the internet.

The latest image has the file relocated to the writable data partition and a symlink in it's place.

in most cases this works well but can cause an issue if events don't happen exactly as expected at the right times during boot up.

Severity column represents the severity of the PMR at the time the APAR was opened.

invalidating stale software suspend images done-83invalidating stale software suspend images done-68

2) Enable the hourly cron job to back-up the current time by temporarily remounting the partition as RW.

These three steps should restore the Pi's timekeeping to it's former Raspbian standard and overcome any issues imposed by mounting the file system as read-only.

Restart the ntp daemon and return to read-only mode Additionally as the accuracy of the data we collect is dependent on an accurate timestamp I suspect a 4th step may be needed to improve the Pi's timekeeping, this additional step could counteract delayed network connections at start up caused by a poor internet connection or even just a router taking longer than the Pi to reboot and get a connection after a power outage.

Having helped a few users with this issue I did some research and this is what I found.

When the ntp daemon is initiated at boot-up it will attempt to correct the current system time that was previously loaded from the file using ntp servers.

Leave a Reply